TN Series Compact Two-Piece Pneumatic Cylinder

They are used for heavy loads and to prevent rod bending and rotation. This design ensures durability and stability of performance. They are produced with piston diameters of 10, 16, 20, 25, 32 mm and piston strokes up to 100 mm. The minimum dimensions of the pneumatic cylinders allow them to be used in places where the compact design of equipment units is important.
On pneumatic cylinders of the TN series, it is possible to install a magnetic ring on the piston, which allows the use of position sensors on them.

The profile liner of the pneumatic cylinder is manufactured by extrusion, as a result of which it has a high surface finish and directional roughness, which reduces wear on the piston seals. On the surface of the sleeve there are special grooves for installing position sensors.
Special high-quality lubrication allows these pneumatic cylinders to be used in pneumatic system without forced lubrication.
The stem is made of steel, the surface is chrome-plated, the surface finish is 0.4 microns, the permissible deviations in the stem diameter are f 8.

To supply compressed air and control a pneumatic cylinder, the following components must be used:

Air preparation (Filter, Gearboxes, Lubricators).
Pneumatic distributors (Electromagnetic, Manual, Pneumopedals);
Fittings (Quick Disconnectors, Collet Fittings);